6. Set your call sign and enable the bands you want to transmit on
then click the Save button.
7. To verify your settings have been stored you can close the serial
port and then open it again, this will re-read all the settings from
the transmitter and you can verify that everything is correct.
8. To start the WSPR beacon click the “Start” button in the WSPR
Configuration section as shown in the picture.
9. Once the WSPR mode has been started it will continually
transmit the WSPR beacon on all bands that are enabled.
If you change something in the software, it will drop out of WSPR
beacon mode and you have to click the Start button again.
