Z A A Z S T U D I O S | U S E R M A N U A L 6
Z A A Z S T U D I O S | U S E R M A N U A L 7
ASSEMBLY INSTRUCTIONS
This advanced design is ergonomically designed and maintains a high level of reliability and smooth
noiseless functionality.
PACKAGING:
Retain all packing materials for your 15K until you are certain you have all components.
COMPONENTS:
The ZAAZ 15K components include the Vibration unit, post, console, handlebars,
tool kit, power cord and User’s Manual.
7.
Put the left long handlebar onto the top of
the post. Attach loosely with the long bolt by
first feeding the bolt through the hole in the
top of the arm and then lining it up with the
hole in the top of the post. Connect bottom of
left arm to the base. Tighten the screws loosely.
Then assemble the right handlebar the same
way. Tighten the top bolts and bottom screws
snugly.
9.
Remove the screws from the underside of the
console and attach to the top of the post. As
you attach to the post, feed the cable down the
centre of the post so you don’t pinch the wires
when you tighten the screws.
11.
To use the body fat measurement function,
remove the protective plastic film from the
sensors on the handles.
13.
Connect the plug to the power outlet, and
press the red switch on the back of the base to
turn on the machine.
12.
Connect the plug to the power outlet, and
press the red switch on the back of the base to
turn on the machine.
NOTE
Re-Tightening of screws and bolts may be
required every 3-6 months, depending on use.
8.
Attach the 3 cables from the underside of the
console to the 2 from the curved handles and
the 1 from the centre of the post.
10.
Tighten all screws and bolts snugly.
1.
Remove all packaging.
5.
Unscrew the 4 screws on both sides of the
base, (2 at the front and 2 at the back).
3.
Connect the cable to the base.
2.
At the top of the post, insert the cable
through the small hole in the middle so it pro-
trudes out both ends. Grip the top of the cable
and don’t let it fall into the post.
4.
Affix the post to the base with the 4 bolts,
using the screwdriver provided or a 12 mm
socket wrench.
6.
Starting with the left handlebar, connect
and screw the handle pieces (A and B) with the
plastic connector (C). Then connect piece D to
the plastic connector. Put the two handlebars
onto the end tubes simultaneously.
NOTE
Tighten all screws only 3 or 4 turns at first.
Tighten the screws until snug (not over-tight)
when assembly is finished.
Summary of Contents for 15-K
Page 1: ...ZA AZ 15K USER MANUAL 15 K ...
Page 11: ...zaazstudios com ...
