4
5
Parts Diagram
Rotating Plug
Protection cover
Replaceable UV-C
bulb
Product base
Plug
Note: The plug type
varies depening on
each country’s
requirements. Please
make sure you have
received the correct
one. The plug type
shown in the above
diagram is ETL plug
type A.
The plug can be rotated by 180° as
shown in Figure a). If your unit has
plug type A like the one shown in
the above drawing, or any other
plug where the positioning of the
prongs can only fit into the power
outlet in one direction, please make
sure it is in the correct position so
that it can fit in the power outlet
properly and so that the unit is sit-
ting right side up.
Instructions for Use
1. Verify that the voltage indicated on the adapter rating label
corresponds with the voltage of your electrical outlet.
2. Since the plug can rotate by 180°, make sure it is in the correct
position so that it can fit in the power outlet properly and so that
the unit is sitting right side up.
3. Plug the unit into the power outlet and make sure the fan and UV
light are both working.
4. For optimal results, let the unit run for at least 2 hours.
5. When the UV-C bulb is ready to be replaced, refer to bulb
replacement instructions below.
Troubleshooting Guide
Figure a)
Issue
Solution
Unit does not work
Check the connection of the power
and power outlet
Call customer service
Flashing lights
The UV-C bulb is burnt out. Refer to
instructions for bulb replacement in
this User Manual
The fan is on without light
