7
CONFIDENTIAL
DOC-USR-0126-03
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
Please refer to the Hardware Specification Document, DOC-USR-0116-0x for more
information.
If the unit is in its case, it is best to leave it in the case, and not disassemble the thermal
pads and copper tape. Since the case metalwork does not have a hole for J5 on the rear
panel, it is recommended to install the mating shell using tweezers, and route the wires out
where possible. The mating shell should be plugged straight into the connector
For a visual guide on accessing J5 in an assembled system,
see Figure.
Serial ports are mapped to software devices as follows:
The RS-232 port (back panel 2.5 mm jack) is /dev/ttyAMA0
The RS-485 port (J5 on connector PCB) is /dev/ttyAMA1
The VISCA control port for Sony camera is /dev/ttyAMA2
