CONFIDENTIAL
Z3-DM8169-4CH-RPS V2.01.30a
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
25
6.8 Start Encoding
(13) Go to the bottom of any tab and click “Start All”:
*Important Note:
It is possible that the Z3-DM8169-4CH-RPS may have already started (if valid input
is connected, it will autostart 20 seconds after booting up). You can tell this if the status in the
lower right corner of the “Channel Controls” box says “RUNNING” (this is the case in the figure
above). If the encoders are running, you should first click “Stop All,” wait for status to say
“STOPPED”, and then click “Start All” for the new settings to take effect.
(14) Click on the “Status” tab (just to the right of “User Presets”). You should see output bitrates, frame
rates, and resolutions for each channel. This is shown on the next page.
*Important Note:
When encoding first starts, it may take around 1 minute for the statistics to ramp
up and have accurate values. When first starting, values for actual bitrate and actual FPS will be
lower than the target.
*Important Note:
Interlaced encode is signified by showing the height per field – for example, an
encode of 1080i will cause a value of 540 for height (as can be seen in the example in the Figure).
Click here
Figure 11 Starting the Encodes
