CONFIDENTIAL
Z3-DM8168-PCI-RPS V1.05.01c
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
20
As shipped the Decoder board will have the same IP address as the Encoder board (192.168.81.68). To be
able to work on the same system, one of the boards should have a modified IP address. In this example we
will change the Decoder board IP address to 192.168.81.67. To do this, perform the following steps:
(6) In the serial menu, type “X” to exit the serial menu.
(7) This should take you to the linux prompt. From here type “fw_setenv ipaddr 192.168.81.67”:
/opt/z3 # fw
_
setenv ipaddr 192.168.81.67
(8) Then reboot the system by typing “reboot –f”:
/opt/z3 # reboot -f
(9) You should then see the Decoder board reboot. In the serial menu, you can verify the new IP address
has taken effect:
(10) In your PC, run a web browser (for best results, Z3 recommends FireFox or Chrome). In this browser,
type http://192.168.81.67. After about 3 seconds, the Encoder Settings menu should come up. You
will change this later to operate as a Decoder. But first, let’s go back to the Encoder and set up the
stream …
Figure 13 New IP Address on Decoder
Changed IP Address
