![Z3 Technology SBE264-10-RPS User Instructions Download Page 68](http://html1.mh-extra.com/html/z3-technology/sbe264-10-rps/sbe264-10-rps_user-instructions_3107896068.webp)
CONFIDENTIAL
DOC-USR-0171-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
68
(UDP Only)
Specifies where to save the TS file. For example,
if a USB drive is connected, the value
“/media/sda1/example.ts” could be specified.
Video PID (UDP Only)
0 – 8191 (
221
)
PID assigned to video in the TS stream.
PCR PID (UDP Only)
0 – 8191 (
521
)
PID assigned to PCR in the TS stream.
PCR Interval
0-999
(50
)
Sets PCR interval value.
PMT PID (UDP Only)
0 – 8191 (
31
)
PID assigned to PMT in the TS stream.
TS Rate (UDP Only)
125K – 20000K (
8000K
)
The rate of the transport stream. Normally, this
value should be set to 1.25 * (video b audio
bitrate). This can be set to higher values to allow
leeway for times when many bits are needed to
encode. This can be especially useful for ensuring
smooth playback at lower bit rates (see Section
7.10, “Adjusting the UDP TS Rate,” on page 31).
TS Lowlat Mode
(UDP Only)
True
False
Normally the TS muxer gathers data into packets
of maximum network size. While this leads to
maximum network efficiency, it can lead to
increases in latency. Turning “Lowlat Mode” on
causes the TS muxer to instead send packets out
as soon as it receives them. This results in lower
latency at the expense of decreased network
efficiency and a less smooth bitstream. If this is
set the bitrate should be no higher than 5Mbps.
Authentication
(RTMP only)
Disable
Enable
Supports entering an authentication User name
and Password for RTMP. When enabled, a “User”
and “Password” text box appear. The user then
enters the appropriate User name and Password.
User
(RTMP Only)
User name to enter when “Authentication”
enabled.
Password
(RTMP Only)
Password to enter when “Authentication” is
enabled.
Frame Align
(Enc 1 to 3 Mode
only)
True
False
This activates frame alignment for a specific
channel. Valid for “Enc 1 to 3” mode only. This
makes sure that different channels with different
resolutions have aligned I-frames. This allows for