36
CONFIDENTIAL
DOC-USR-0101-01
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
10.2
The CH1 Tab
Parameter
Options
(default in bold)
Notes
Video Source
HDMI
The video source selected for encode.
Selection of “HDMI” will supports video from the Sony
FCB-ER8300 via the KEL ribbon cable.
Output Resolution
176x144 – 3840x2160
Follow Input
The encode resolution. If this resolution is different
from the capture resolution, resizing will occur.
“Follow Input” generates the resolution based on the
capture resolution. [
Note 1
]
Video Codec
H265(HEVC)
H264(AVC)
Selects whether video is encoded by H.265 (HEVC) or
H.264 (AVC).
Video Rate Control
VBR
CBR
Selects the encoder rate control mechanism. VBR
(Variable Bitrate) means that the encoding bitrate
can fluctuate within the bitrate statistical period.
CBR (Constant Bitrate) means that a stable encoding
bitrate is ensured within the bitrate statistical time.
Video Bitrate
2K – 40M (
4M
)
Textbox for entering video bitrate.
Frame Rate
Full
Half
Quarter
Sixth
Used to encode at less than the input frame rate (for
example, an input frame rate of 30fps with “Half”
selected would cause an output stream of 15fps). If
interlaced input is used then this is used to reduce
the number of fields being encoded.
GOP Size
10 – 240 Frames
(
60 Frames
)
I-frame frequency.
Video max delay
300
Textbox for entering maximum delay.
Output Format
UDP
RTP
RTSP
TSRTP
Output format of the encoded IP stream.
If UDP is selected, don’t forget to check the value of
TS Rate to make sure it is in line with expectation.
RTP requires an SDP file for the receiver that
corresponds with the video codec used.
RTSP requires the use of the RTSP URL.
TSRTP causes streaming of TS over RTP.
Dest Address
192.168.x.y
(192.168.0.6)
The IP address that the encoder is streaming to.
Dest Port
0 – 9999 (
5004
)
The port that the encoder is streaming to.
Video PID (UDP Only)
0 – 8191 (
221
)
PID assigned to video in the TS stream.
PCR PID (UDP Only)
0 – 8191 (
521
)
PID assigned to PCR in the TS stream.
PCR Interval (UDP
Only)
(
50
)
Interval assigned to PCR in the TS stream.
PMT PID (UDP Only)
0 – 8191 (
31
)
PID assigned to PMT in the TS stream.
TS Rate (UDP Only)
125K – 20000K (
5000K
) The rate of the transport stream. Normally, this
value should be set to 1.25 * (video b audio
bitrate). This can be set to higher values to allow
