HE4K-DCK-1X User Instructions
DOC-USR-0123-06
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
52
(4)
Enter your selected password and click
login
to access the user interface.
8.8
Factory Reset
The HE4K-DCK-1X can be reset to its original factory settings using the pinhole reset on the lower right of
the rear interface panel of the unit.
Figure 57 Pinhole Reset
(1)
Allow the camera to boot completely.
(2)
Press and hold pinhole reset switch until status light flashes yellow
(3)
Power cycle camera. Once the boot sequence has completed the camera will return to its original
factory settings.
8.9
Using Wi-Fi
The supported USB Wi-Fi card at the time this document was written is the TL-WN722N v2. If you find that
your card is not working as described in the document ssh in to the board (ssh
) and run
lsusb at the prompt. You should see this entry:
Bus 003 Device 002: ID 2357:010c
Figure 56 Password Entry Screen
