Control with single buttons In this mode a group of devices is controlled by a single button: single click
turns 'ON'; double click turns 'OFF' devices in the group. In case dimmers are controlled, holding down the
button will dim up, click and hold down will dim down the load. The group number corresponds to the button
label.
Control Commands:
The configuration parameter #11…#14 specifies what commands are sent when the buttons are operated.
Direct Control of associated devices using 'ON', 'OFF', 'DIM UP' and 'DIM DOWN' The special
commands 'ALL ON' resp. 'ALL OFF' are sent as broadcast to all devices in direct wireless range. The
devices act according to their individual settings for 'Switch ALL' commands. This mode implements the
communication pattern 7.
Simple Scene Activation using configurable scene control commands.. Associated devices in an
association group are controlled by individual commands defined by Z-Wave command class 'Scene
Controller Configuration'. One scene number can be configured per association group. On default, the
scene number equals the association group number as shown in the figure below. This mode implements
communication patterns 6 and 7. This mode is typically used to activate scenes in IP gateways but can also
be used to activate predefined scenes in other scene-capable devices.
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 5
