note: User code ID range is 1~30,
User code Status 0x01, User code length is 4~10,
Remove
user code
1. Z-Wave
TM
Controller use Command Class User
Code
2. Use Command User Code Set
3. Set User code ID, User code Status, User code
note: User code ID range is 1~30,
User code Status 0x00, User code length is 4~10
Notification
1.type user code then can send Alarm report
2.
Behind the panel it have a tamper key
if Disassembly the pad, and release tamper key it
can send tamper report
association The device support one group, group one is for
receiving the report message, like
1.Reset
2.Scene report
3.alarm report
4.low battery
One group support 5 nodes maximum.
Smart start
1.Product has a DSK string, you can key in first
five digit to increment smart start process, or you
can scan QR code.
Ex: mydsk
10209-46687-52248-13629-04783-07465-15776-
56519
2.SmartStart enabled products can be added into
a Z-Wave network by scanning the Z-Wave QR
Code present on the product providing SmartStart
inclusion. No further action is required and the
SmartStart product will be added automatically
within 10 minutes of minutes On in the network
vicinity
Entry Control Function
DisArm
mode set
1. Make sure keypad in Entry Control mode
2. enter user code then ENTER
3. Keypad will send disarm report, And
change to Central Scene mode.
Arm mode
set
1. Make sure keypad in Entry Control mode
2. enter
3. Keypad will send arm report
Central Scene Function
Central
Scene report
1.Make sure keypad in Central Scene mode or
already type user code.
2.Press 1 or 2 times in 2 sec. or hold on for 2
sec. or release any one of key.
6
