Z-Wave Aeotec 7 Pro, Manual, Page: 5 / 13

Screw Terminal
The product must support the interconnection of external binary sensors as well as actuators
and dry-contacts. The product allows interconnection with external sensors/actuators via 3-pin
screw terminals with the following pinout:

#1: Ground

#2: Digital Input

#3: VCC (direct battery supply)
VCC + Ground terminals can be used to externally power the sensor with a 3.6V battery or special power
adapter (which is not included in the scope of delivery). D VCC is used to connect the external dry
contact.
Link testing
When activated by configuration parameter #5 the device can perform a link test. Double-clicking the
tamper will start the process. As a result, the GREEN LED will blink two times in case of success and the
RED LED will blink two times in case of failure.
Scene Controller
When activated by configuration parameter #14 the device can perform as a scene controller. D
VCC is used to connect the scene button. The external dry contact will then act as a scene controller with
a total of 7 scenes that can be activated:

1 - Contact Pressed 1 time

2 - Contact Pressed 2 time

3 - Contact Pressed 3 time

4 - Contact Pressed 4 time

5 - Contact Pressed 5 time

6 - Contact held down

7 - Contact released
The device sends the following notifications to the central controller:

Window Opened(0x06 - 0x16)

Window Closed(0x06 - 0x17)

Tamper Removed(0x07 - 0x03)
The device sends the following sensor binary reports to the controller:

Tilt(0x0B)
Node Information Frame