The standard magnet covered by plastic part, mountable beside the sensor. Make
sure the two indicating lines on sensor enclosure and magnet are opposite to each
other. The image on the right-hand side shows the position of magnet and sensor
body.
A slim naked magnet to be mounted behind the sensor in case the sensor body is
placed on the side of a window.
To use the tilting function, the opening angle of the window must be at least 5°.
For German-style windows where the window sits on top of the
window frame mounting on the side of the window is highly recommended. If no
tilting detection is used, the sensor can be placed on any position of the door or the
window. In case tilting detection is desired the sensor should be placed on the upper
side of the window.
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to
an existing wireless network
to communicate with the devices of this network. This process is
called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both processes are
initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion
respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right
on the device.
Inclusion
1. Open the housing.
2. Remove the battery protection.
3. Press the tamper on the side of the appliance three times quickly.
Exclusion
1. Open the housing.
2. Press the tamper on the side of the appliance three times quickly.
Product Usage
Once installed the sensor will report "open" and "close" status changes to a central Z-Wave controller
using notification commands. Additionally, the sensor can directly control other devices using association
group 2. Using configuration commands the source of "open" and "close" events can be chosen between
the internal magnet detector or external dry contact connected via the screw terminal. The device is
protected by a tamper switch.
Tilt detection
The tilt detection allows reporting the way a window is opened. This is accomplished using the command
class "binary sensor - tilt-type". In case the window is closed or opened without tilting the tilt sensor will
report "Off". In case the window is tilted an "On" is reported. The angle of inclination of the window must
be at least 5°.
Summary of Contents for Aeotec 7 Pro
Page 1: ...Door Window Sensor 7 Pro ...