7
2.MOUNTING THE HOPPER TO THE CHAMBER
1.Remove the 4 Gaskets and Bolts from the Hopper, open the Lid, insert the Hopper into the
Chamber, then using these Bolts and Gaskets install it in sequence from inside. (Note: The
Bolts need to go through the Locating Bracket (16))
2.Locate the RTD plug-in connector coming from the mounted RTD inside the grill frame.
Connect this with the mating connector located on the outside of the hopper burner
assembly. NOTE: excess wire on the RTD plug should remain outside the Chamber.
3.Insert Bolt (C) through the Hopper Handle (40) and into the Hopper.
3.INSTALLING THE CHAMBER HANDLE TO THE LID:
Remove the Gaskets and Bolts from the Lid Handle (9). From the inside of the raised lid,
push the Blots through the Gaskets and then through the lid (11) and Handle Guide (10).
Handle should sit inside the depression in the guide. Thread Bolts into Lid Handle (9) and
tighten with Wrench (B).
