10
2.MOUNTING THE HOPPER TO THE CHAMBER
1. Take out the screws attached to the Hopper, and then assemble Hopper Lid(27) to the
Hopper through hinge holes by these screws.
2. Open the Lid, insert the Hopper into the Chamber, then using the Bolts (E) and Gaskets
(D) install it in sequence from inside.
3.
Screws (A) need to be threaded through the Grease Drain Pan Support (26) into the
Chamber. Tighten with Screwdriver (H).
3.ATTACHING THE SMOKE STACK AND HOPPER HANDLE
1.Insert Screws (A) through the Hopper Handle (30) and into the Hopper (17).
2.Align the holes in the Smoke Stack (8) with holes in the Smoke Stack Gasket (7), which fits
between the right end of the Grill and the Smoke Stack Gasket (7). Insert the Hexagon Bolts
(F) through the holes in the Smoke Stack (8) and the Smoke Stack Gasket (7). Align the hole
of grill body, then attach the Gasket (D) and Hex Nut (G). Finally use Wrench (I) to tighten
them. As shown.
3.Tighten the Chimney Cap (9) on the Smoke Stack Assembly (8). Note that the chimney is
vertical and then tightened.