6.
Use a center punch where it is practical to
dimple the pole you are going to drill.
7.
Try drilling a pilot hole with a small
diameter bit. If you are successful in drilling
the hole without the bit slipping, and are
satisfied with the results, step up to larger
bits until you have a sufficiently large hole
for your purpose.
8.
Insert the M5xL40 screw into the drilled
hole and use the nut to tighten to secure
the
bracket
to
pole.
If
there
is no significant
movement,
you
are
probably tight enough. If the M5xL40
screw is not long enough to secure the
bracket, use other longer screw instead.
Pole Mount _Vertical
Pole Mount _Horizontal
MOUNTING ON A FLAT SURFACE
1.
Attach the bracket
①
on the LTE-Fi AP
using the four M5xL10 screws.
2.
Mark two screw holes with bracket
②
on
the place you have selected where the
power is available nearby on the vehicle.
3.
Use a drill to create two holes on the two
markings you created in the previous step.
4.
Attach bracket
②
on the bracket
①
using
three M5xL10 screws and nuts.
5.
Attach the cable cover to the junction box
using the screws from the removed cover
plate.
6.
Insert two M4xL20 screws into the
installation holes and tighten up.
Flat Surface Mount _Bottom
Flat Surface Mount _Top
