DISTRIBUTION ZHC
User Manual and Installation Guide
12
SLAVE SET-UP
1. Perform the same procedure for each closet
2. Make sure that the Master is set-up and functioning correctly.
3. Make sure that Coax from Master or lower level cascade(s) are connected
4. Always start with the lowest level cascade in the closet. Power just that unit. When first
powered all 3 LED’s on front Panel come on. Within 30 sec’s the top RED LED will go off and
only the Yellow and Green LED will be lit. This indicates the unit is in Slave.
5. The unit will remain unlocked until the unit has measured a steady tone for ~20 mins. This is
indicated by a flashing Green LED on the rear of the enclosure.
6.
When the unit has detected a steady tone for 20 minutes the unit will lock, as indicated by a
solid RED LED on the rear of the enclosure. A locked unit will stay in Slave, retaining the
output setting that it has established, even thru Power cycling. If the set-up needs to be
FRONT PANEL
M
S
P
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
CATV/CAS
IN
OUTBOUND COAX
LC/APC
FIBER
MGMT
Z-Distribution
ZHC
A
B
12VDC
USB
•
When powered all 3 LED’s on
•
After ~30 secs RED LED off
•
Unit is now on Slave
Solid Red indicates
Locked Slave
Flashing Green indicates unit in
Slave but still waiting for 20 mins
of consistent signal
Pushing in “B” button for 10 sec “unlocks”
unit and places back to original factory
settings
REAR OF
ENCLOSURE
