Z Automotive Tazer DT, User Manual

Page: 7 / 16

7
• Light Shows
“ LightShow? ”
:
Activate pre-
programmed and custom light shows, even when the
engine isn’t running.
• Read DTCs:
View any error codes in the
Powertrain Control Module (PCM)
Body Control Module (BCM)
Transmission Control Module (TCM)
Anti-lock Brake System (ABS)
Drivetrain Control Module (DTCM)
Radio Frequency Hub (RFH)
Drive Assistance Module (DASM)
Occupant Restraint Controller (ORC)
ParkTronic System (PTS)
OBD Readiness Monitor (Readiness)
• Clear DTCs:
Clear any error codes in those same systems
• “Marry”:
To advance to any of the vehicle settings,
you will first need to “Marry” the Tazer to the vehicle.
When you select this option, the Tazer will download your
car’s current (presumably stock) settings. This should
take around 15 seconds. Do not disturb this process.
This option will change to “Unmarry” once Married.
See the previous page for details.
• Submenus:
Once married, you can advance though
several sub-menus. Select a submenu using the method
described above. Submenus and their contents are
listed starting on the next page.
“ Perf? ” PERFORMANCE SUBMENU
“ Tire? ” TIRE SUBMENU
“ Radio? ” RADIO SUBMENU
“ Light? ” LIGHTING SUBMENU
“ Offroad? ” OFFROAD SUBMENU
“ Other? ” OTHER SUBMENU
• Firmware Version Display
“ TZDT: x.x.x. ”
:
Shows the current Tazer firmware revision.
• Unmarry Number
“ UnmryNo: XXXX ”
:
Shows the
current “Unmarry Number” ( see page 13 ).
• Full Reboot
“ FullReboot? ”
:
This option resets
vehicle modules and the UConnect system twice. The
dash will reset. When finished, the red dash security
dot will turn on. It may turn off or not depending on the
vehicle. This takes 2.5 minutes and should be performed
after any Vehicle Settings are changed. Follow with two
sleep cycles as described on the previous page.
• For all functions involving the dash (EVIC)
display, the EVIC screen first needs to be
in a state where it’s showing the AUDIO
screen. Navigate to this screen using the
steering wheel arrow buttons.
• Once the display is in this state, use the
button commands below to operate your
Tazer DT.
Menu Navigation
Function
Button Input
OPEN MENU/SCROLL MENU
◁
(HOLD) + CRUISE CANC
SELECT/CHANGE OPTION
or
SAVE VALUE
(TIRE SIZE, TPMS THRESHOLD, ETC.)
◁
(HOLD) + CRUISE ON/OFF
ADJUST VALUE
(TIRE SIZE, TPMS THRESHOLD, ETC.)
◁
(HOLD) + /-
Vehicle Settings
This section explains the Vehicle Settings, used primarily
for feature activation.
The Vehicle Settings menu is accessed with the ignition in “Run” (not
“ACC”) and the engine NOT running.
The menu items are listed in the order in which they will display.
Main Menu