YZ Systems NJEX 6300G, Instructions & Operating Manual, Page: 48 / 128

YZ Systems Milton Roy • 201 Ivyland Road • Ivyland, Pennsylvania • USA • 18974 • P: 281.362.6500 • www.yzsystems.com
Page 38 NJEX EUR ver. 08-2021
Section 6: Programming for Proportional-to-Time Operation
Setting Operator Input Parameters,
Continued
MODBUS Parameters
COMM = . . ONLY Communications Port #2 will be
available for communications using Sentry Soft-
ware Communications Protocol.
COMM = 1 . Communications Port #1 will be available
for Modbuss Communications, and Communica-
tions Port #2 will be available for communications
using Sentry Software Communications Protocol.
COMM = 1 2 Communications Port #1 and Commu-
nications Port #2 will be available for Modbuss
Communications, and NO ports will be available
for communications using Sentry Software Com-
munications Protocol.
Conclusion
This concludes programming the N-300G controller in
Proportional-to-Time Mode. If the NJEX System is the
only unit that will be initialized at this time the follow-
ing Section 7, Calibrating Signal Inputs will contain the
next appropriate information based on Proportional-to-
Time Mode operation.