Charging Pile Instructions-V2.0
18
9. Operation Instruction
9.1 Checks before Charging
9.1.1 Safe checking before charging
➢
Ensure that the products has no scratching, rust, deformation and other damages.
➢
Ensure that the power supply socket is safe enough and no residuals left inside the
plug and vehicle inlet.
➢
Please stop using immediately if charging cables were found exposed or plugs shell
damaged
➢
Keep the plug always in dry state. In case of water accumulation, please clear the
water with dry and clean cloth under totally power off state.
9.1.2 Attentions in Operation Process
➢
If the fault light was on or in fault displayed in the screen, please stop using and
contact the staff for help.
➢
When multiple charging connectors are used simutanously, special attention need to
be paid when swiping the card for settlement. Please check carefully about the
charging plug used is plug A or B before the settlement to avoid misoperation.
➢
Please refer to relevant instruction when operate the charging equipments.
➢
Pay attention to insertion and extraction force of the vehicle connector to avoid
overexertion.
➢
Ensure that the vehicle connector is completely connected to the vehicle inlet, and the
plug is completely perpendicular to the vehicle without any external influence.
➢
In the process of swiping the card, a prompt beep will be given out if the card swiping
process is successful, otherwise the operation may fail.
➢
In case of emergency, please press down the emergency stop button. Charging is not
allowed after that. If charging pile is in working state, charging process will be
stopped immediately also.
➢
A regular check of the lightning arrester firing pin or indicating window needs to be
carried out. If the firing pin is protruded or indicating window turned red, it means the
