YURAKU PTE LTD
11 Collyer Quay
#10-04 The Arcade
Singapore 049317
www.yuraku.com.sg
Modules may be mounted using the following methods only:
1)
Frame Holes
: Secure the module to the structure using the factory mounting holes. Four 8mm
stainless steel bolts, with nuts, washers, and lock washers are recommended per module. Refer
to Table 2 for the module dimensions and hole locations. This method has been certified by a
third-party organization according to UL 1703.
2)
Pressure Clamps or Clips
: Mount the module with the clips on the side frame of the module.
The side frames are attached to the longer sides of the module. The centerline of the clips
should be 6 -15 from the end of the side frame. Installers should ensure the clamps are of
sufficient strength to allow for the maximum design pressure of the module. Clips and clamps
are not provided by YURAKU.
3)
End Mount
: End mounting is the capture mounting of the length of the module’s end frame to
a supporting rail. The end frames are on the shorter dimensions of the module.
The end-mounting rail and clips or clamps must be of sufficient strength to allow for the
maximum design pressure of the module. Verify this capacity with the mounting system vendor
before installation.
7.0 Maintenance
7.0 Maintenance
7.0 Maintenance
7.0 Maintenance
Inspect all modules annually for safe electrical connections, sound mechanical connection, and
freedom from corrosion. Periodically clean the module surface with water and a soft cloth or
sponge. Fingerprints may be removed with standard glass cleaner. Do not use harsh cleaning
materials such as scouring powder, steel wool, scrapers, blades, or other sharp instruments to
clean the glass surface of the module. Use of such materials will invalidate the product warranty.