YUNEEC Typhoon H Plus, Maintenance, Troubleshooting & Parts

Page: 37 / 43

37
Yuneec Part Number
*
Nomenclature
Used on
YUNTYH135 SR24 Receiver Board (
US version
) ALL
YUNTYH136 Landing Gear Circuit Board ALL
YUNTYH142 Main Internal Frame ( used w/YUNTYH120 ) H & H Pro Only
YUNTYHBP001 Typhoon H Soft Backpack
YUNTYHFSPO90 100-240V AC to 19V DC Power Supply (
NO powercord
)
YUNTYHP101 5250 mAh LiPo Battery Typhoon H Plus (
15.2v
) H+ & H520
YUNTYHP112 H+ (Plus) Upper Cover (
has H Plus LOGO
) H+
YUNTYHP113 H+ (Plus) Motor LED Cover H+ & H520
YUNTYHP120 H+ (Plus) Motor H+ & H520
YUNTYHP121 H+ (Plus) Tri-Color Light Circuit Board (
under motor
) H+
YUNTYHPBP Typhoon H Plus Backpack
YUNTYHR RealSense Module ver 1 H & H Pro Only
YUNTYHR102 Lower Cover RealSense Module ALL
YUNTYHR104 Cooling Fan RealSense Module ALL
YUNTYHR105 UltraSonic Sensor RealSense Module (
on bottom
) ALL
YUNTYHSC4000-4 Battery Charger SC4000-4 H & H Pro Only
YUNWZD Wizard Wand H & H Pro Only
*
NOTE: Some part numbers may need "SVC" add at the end if searching on the Internet - Its Yuneec's way of
saying the part needs to be done by a service center - this is not always TRUE.
DO NOT
confuse Typhoon H or H Pro (H480) with the Typhoon H Plus
Some parts will work YES (ie body parts) but NOT all (ie Propellers or arms)
Yuneec's Part ID Naming:
YUN - is for YUNEEC
Next 5 characters are for the Model or Equipment
Cameras: CGO - CGO/CGO2 Camera, CGO3P - CGO3+ Camera, C23 - C23 Camera and so on
Aircraft: TYH - is the H/H Pro (H480), TYHP - is the H +, H520 - is the H520 and so on
TYH R - is the RealSense components - which apply to all the Typhoons
Next is a sequence number followed by an A or B in some cases i.e. arms and props
*
NOTE: Some part numbers may need "SVC" add at the end if searching on the Internet - Its Yuneec's way of
saying the part needs to be done by a service center - this is not always TRUE.
DO NOT
confuse Typhoon H or H Pro (H480) with the Typhoon H Plus
Some parts will work YES (ie body parts) but NOT all (ie Propellers or arms)
99% of the electronic components will need to be done by a service center as they will require Yuneec's
proprietary software to setup/calibrate in order to properly function/work with your system. i.e. Camera
components, transmitters/receivers etc.