Yunca_NZW_Operation & Warranty - DEC_2016.doc Page 2 of 6
SAFETY INFORMATION
General:
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
For the protection of young children, install an effective fire safety screen around your fire. Always keep
children well away from the wood burner when it is alight.
Supervise young children to ensure they do not play with the appliance.
During initial burns, ventilate the rooms well. It is recommended that babies, small children, pregnant
women and pets should leave the area during initial burns as this is the firebox paint curing period.
Do not make any modifications to the unit, and use it only in the manner described in the manual. Using it in
any manner not recommended by the manufacturer may result in injury or death.
For units including electrical connections:
If the wood burner is permanently connected to an electrical source, an isolating switch (wall switch) must
be installed.
Whenever new circuits or modifications are required, use services of only a certified electrician.
Ensure that the outlets you use are grounded properly, polarised and provided with fuse units.
Ensure that the electrical plug is accessible after installation. The wood burner must not be located
immediately below an electrical socket.
Never operate the appliance with a damaged plug or cord, or if you observe the fan unit is malfunctioning or
the heater has been damaged in any way. Call the authorised service person immediately for repairs or
making electrical or mechanical adjustments.
– Isolate the electrical supply in order to alleviate any
potential risk.
If the supply cord is damaged, the manufacturer, its service agent or a suitably qualified person must
replace it in order to avoid electrical hazard. Any cord similar to the original can be used.
For further details, refer to the model-specific installation instructions.
IMPORTANT INFORMATION
A.
THE APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED IN COMPLIANCE WITH AS/NZS 2918:2001 AND
THE APPROPRIATE REQUIREMENTS OF THE RELEVANT BUILDING CODE OR CODES.
B.
APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD SHALL COMPLY WITH THE
REQUIREMENTS OF AS/NZS 4013 WHERE REQUIRED BY THE REGULATORY AUTHORITY I.E. THE
APPLIANCE SHALL BE IDENTIFIABLE BY A COMPLIANCE PLATE WITH THE MARKING
“TESTED TO
AS/NZS 4013
”
C.
ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN APPROVED IN WRITING BY THE TESTING
AUTHORITY IS CONSIDERED TO BE IN BREACH OF THE APPROVAL GRANTED FOR COMPLIANCE WITH
AS/NZS 4013
D.
MIXING OF APPLIANCE OR FLUE SYSTEM COMPONENTS FROM DIFFERENT SOURCES OR MODIFYING
THE DIMENSIONAL SPECIFICATION OF COMPONENTS MAY RESULT IN HAZARDOUS CONDITIONS.
WHERE SUCH ACTION IS CONSIDERED, THE MANUFACTURER SHOULD BE CONSULTED IN THE FIRST
INSTANCE.
E.
CRACKED AND BROKEN COMPONENTS E.G. GLASS PANELS OR FIRE BRICKS, MAY RENDER THE
INSTALLATION UNSAFE.
