DO NOT RETURN STORE. For questions regarding assembly and use, call Customer Service: 877-441-6999.
Yukon Trail Owner’s Routine Maintenance Guide
1) When do I charge my Yukon Trail Vehicle?
a.
Your Yukon Trail Vehicle is equipped with lead acid batteries. These batteries have no memory. However,
it is recommended to opportunity charge these batteries even after minimal use.
b.
When the red light begins to blink on the dashboard, you have approximately 1-2 miles of usage left.
Charging the vehicle will take approximately 10-12 hours depending on the state of discharge.
c.
Note: It is normal for your onboard charger’s operating temperature to be quite warm. This charger is fin
cooled, not fan cooled. The best way to charge your Yukon Trail vehicle is to open the front seat or prop in the open
position to help dissipate the heat created by charging the vehicle.
2) How do I charge my Yukon Trail Vehicle?
a.
Your Yukon Trail Vehicle is equipped with an onboard charger that is multiple rated and operates on a
standard single pole 15-Amp breaker in applicable mode.
b.
This charger has a pigtail plug, which you attach to the supplied AC cord and then plug into the wall outlet.
3) How will I know when my unit is completely charged?
a. Your onboard charger unit has an LED light that indicates completion of battery charge. A green light
display indicates a full charge. Your onboard charger will automatically shut off after charging is
complete. (Refer to Page 6 of your Owner’s Manual for more details related to your onboard charger.)
4) What is the purpose of the toggle switch on the dash?
a. This button turns the reverse buzzer on or off.
5) What tire pressure should I keep in my tires?
a. See manufacturer’s recommended inflation pressure located on the tire sidewall.
6) What parts of my Yukon Trail vehicle are not covered under the 1-year manufacturer warranty?
a.
Tires and lighting bulbs.
b.
Any and all damages to unit due to incorrectly performed maintenance and charging procedures.
c.
Pick up and delivery of vehicle.
d.
Vehicles used for commercial purposes carry a one-year warranty.
7) How do I clean my Yukon Trail Vehicle?
a.
Turn the key to the OFF position and remove before washing the vehicle.
b.
Wash with soap and water. All parts of vehicle can be hosed off including battery terminals. Be sure to
run the car after washing as the brakes may lock up if car is left to sit in place.
c.
Do not concentrate water stream in location of black box located in the center of the battery box. This is
where the controller and electronics are located in your vehicle.
