1: Place the Velcro through the string and pull the leash
so the knot is at the bottom of the first Velcro pocket.
1: Remove the fins from the protective pouch. You will
have two left and two right fins.
2: Slide the front of the fin into the fin box. Making sure
that the fork cradles the locking pin.
3: Rotate the fin until the fin is completely set into the
fin box. Powerful magnets help hold the fin in place, and
make for easy installation and removal.
1: Insure the battery latches are in the open position
with the tabs straight up.
2: Make sure the battery safety magnet is removed from
the battery.
3: Lower the battery into the cavity.
Optional: A locking set screw and key is provided if you
wish to lock your fins to your YuJet surfboard. To lock
your fins to the board simply screw in the setscrew with
the provided key until you feel a resistance. This is
usually about 4-5 turns of the key.
3: To install the leash on your ankle, choose your rear
foot and open up the Velcro. Put the leash line towards
the back of your foot. Seal the Velcro to finish.
Note: The leash is equipped with a small pocket to keep
your vehicle key in while using the YuJet.
2: Fold the Velcro so the knot is capture in the middle
and then seal the rest of the Velcro tabs as pictured
above.
BOARD SETUP
INSTALLING THE LEASH
INSTALLING THE FINS
INSTALLING THE BATTERY
Summary of Contents for Surfer
Page 1: ...QUICK START GUIDE ...
