g
Tighten the securing screws on the brake rotor side alternately with only one
turn per screw. This is the only way to achieve even clamping (tighten each screw
to 3 Nm using a 4 mm Allen wrench).
Before tightening the securing screws on the other side, press down on the fork
once and let it rebound and install the screws just as you did before:
Tighten them alternately to 3 Nm using a 4 mm Allen wrench.
INSTALLING PEDALS
a
c
b
a
Place the pedal washer on the pedal axle.
b
Apply suffi cient grease to the pedal thread.
Excess grease can be wiped away after the pedals have been installed.
c
Install the pedals using an Allen wrench (the size will vary by pedal manufacturer). The
drive side pedal has standard threading and the non-drive side pedal has reverse thread-
ing. Therefore, the non-drive side pedal is tightened by screwing it in counterclockwise.
Tighten the pedals using the torque wrench.
Please note the torque specifi cations of the manufacturer here as well.
STEP
10
g
eng
