YT Industries TUES MKIII, Installation, Removal And Maintenance

Page: 13 / 26

y t 1 3
EN
SERVICE
LINK
Remove the lower rocker link axle from the
main frame with an 8mm allen key.
Apply fresh grease to the bearing covers in
order to prevent dirt and water ingestion. A
light coating of grease on the axle and bearing
covers is enough.
Remove both rocker link plates in order to
access the bearings.
Install the axles and bearing covers in the
non-drive side rocker link plate, then guide the
whole assembly into the frame pivot points.
Remove the bearing covers and clean off any
dirt and grease.
Install the drive-side bearing covers and
screw the axles into the rocker link plate on
this side. Apply a medium strength thread
lock here.
1.7
1.10
1.8
1.11
1.9
1.12