Setting up YOYORouter BE5 in Ethernet WAN Mode with Failover
First configure YOYORouter BE5 in Wireless WAN Mode and test the connection.
Next, configure YOYORouter BE5 in Cable and test the connection.
To enable WAN Mode with Failover, ensure that your SIM Card is inserted and the Ethernet WAN is
connected and follow these steps:
1. Log in.
2. Select
Advanced
then
Network Setup
.
3. Against
Activate WWAN for Auto-Failover
• Check
Enable
.
• Enter an IP address in
Remote Host for keep alive
that YOYORouter can ping to check the connectivity.
4. Make sure that Connection Control is set to
Auto Reconnect (always on)
.
5. Click
Save
.
6. Click
OK
and allow YOYORouter to reboot.
7. Check that YOYORouter is normally connected to the cabled WAN connection
• System Status shows cabled connection details.
• Wireless Modem indicates
Disconnected
.
8. Unplug the cabled WAN plug and check that Failover occurs:
• 3G Failover indicated in System Status.
• Wireless Modem indicates
Connected
.
9. Re-connect the cabled WAN and check that service reverts to the WAN connection.
