20
[II]
Aux1
[III]
Aux2
Real Time Remote Paging Functions
19
Aux 1 will go out if the button II is pressed for 1/2 second.
There are four different types of outputs (Consult your installer) that are used to
operate a sunroof, a mirror or any other auto accessories.
Aux 2 will go out if the button
III
is pressed for 1/2 second. Likewise, it has 4
different types of outputs.
Note :
1. The duration of the Aux output should be vary depending on the
equipments that these outputs operate.
2. These Aux outputs are 250 mA outputs. Therefore, please use relays
if you connect these outputs to equipment that uses more than 250 mA.
Otherwise, you will damage these output circuitries.
3 .These Aux functions will require extra installation fees.
Please consult your installer.
Types :
R.P.S(Remote Paging System), Theft and Shock Sensing Whenever
one of these is triggered, it is reported to the remote with beeps and flashing
icons in the LCD. In case when the owner has not been alerted, the remote
continues making beeping sounds until turned off.
Theft
–
one beep every 2 seconds ;
Shock Sensing
–
one beep every 4 seconds ;
R.P.S
–
one beep every 6 seconds.
These functions will be availed while the vehicle is armed.
R.P.S(Remote Paging System)
Keyless Entry with R.P.S. sensor
R.P.S is a feature that allows an individual to page the owner of a vehicle
by simply tapping the R.P.S sensor on the front windshield of the car.
This vibration is detected and your remote-pager will ring four times and
a telephone icon will appear on the LCD indicating that someone is paging you
from your vehicle.
With the new patented RPS system, you can open the door without a key or a
remote.
Programming 4 number pass words (1111- 9999)
●
Step 1:
Key On
●
Step 2:
Door Open
●
Step 3:
Knock 10 times. Each time the green LED will flash once.
It should be less than 1.5 seconds between the knocks.
●
Step 4:
The red LED will flash rapidly. If it doesn’t, go to the step 1.
●
Step 5:
Enter your 4 number pass words by knocking - each number 1-9.
To enter the first number, knock the same number of times. The
interval between the knocks should be less than 1.5 seconds. Then,
wait to confirm by counting the number of flash of the red LED. If the
red LED flashes a wrong number, go back to the step 1. If the red
LED confirms a correct number,continue entering the other 3
numbers.
●
Step 6:
Signal Lights will flash once to confirm the programming.
All manuals and user guides at all-guides.com
all-guides.com
