Assembly
5.8m Platform Height: Add 2m Extension
Pack And Use Medium (SP10) Stabilisers
15
For the 5.8m height 2 further 8 Rung Frames will be
required plus additional Diagonal and Horizontal Braces,
and a further Trapdoor Platform. Build as shown in
stages 11 to 14
, taking paticular care to ensure that you
are fully protected by Guardrails on a Platform during as-
sembly.
Should the platforms or braces obstruct on any one
level, simply re-position one of these components by
one rung to suit.
Dismantling
The dismantling procedure should follow steps 1 through
to 14 in the reverse order, but taking particular care with
the gradual removal of Guardrails and Platforms. You
should ensure that you are standing in a safe position and
protected by Temporary Guardrailing, ensuring that no
Diagonal Braces or Stabilisers are prematurely released.
1
Remove Toeboards and upper Guardrails.
2
Go down to lower platform, remove upper platform.
3
Move lower platform and Guardrails up two rungs, so
that you can handle the components above without
over-reaching.
4
From the upper platform, remove Guardrail Frames and
their Guardrails.
5
Remove remaining platforms, 8 Rung Frames, upper
Guardrails and Diagonals.
15
16
Assembly
Lower Height Setting
Platform Height = 1.7m
Working Height = 3.7m
Packs Required
1 × Base Pack
1 × Guardrail Pack
2 × Small Stabiliser Packs (if used externally) For internal
use stabilisers are not required if horizontal forces are
less than 20kg.
Fitting Toeboards
Start with the End Boards which have red plastic clips.
There are two slots depending on which side you posi-
tion the diagonal brace. Clip into correct slots, as shown,
ensuring that no large objects can fall through and that
the trap door can open with ease.
17
