BoSS Ladderspan
User Guide
youngmangroup.com
youngmangroup.com
5
Climb up the inside of the tower and from the protected
position of the trapdoor, fit guardrails to the 7th and 8th
rungs, (in that order), on both sides of the tower.
6
Continue the procedure until the required working height is
reached, adding additional pairs of end frames, diagonal
braces and fitting trapdoor platforms, as shown on previous steps.
At every platform level, add horizontal braces as guardrails from
the protected position within the trapdoor, (as shown in
step 5
).
Fit a single diagonal at the top of the tower as shown.
Fit the toeboards (see instruction on
page 29
).
The tower is now complete.
Assembly Procedure
27
Assembly Procedure
28
7
To take down the tower reverse the building sequence.
When removing guardrail braces, unlock the 4 claws
furthest from the trapdoor and then return immediately to the
protected position within the trapdoor. You may then unlock the
claws at the other ends of the guardrails to remove them from the
tower.
Dismantling Procedure
Lock yellow plastic toeboard clips over rung and deck claw as
shown. Position as
(A)
on right hand deck claw. On other side of
the working platform, position the clip as
(B)
. Place 25mm thick
toeboards into slots in toeboard clips as shown.
Toeboards
Mobile Towers - 3T Method
FITTING TOEBOARDS
29
Side Toeboard
End
Toeboard
Toeboard Clip
Claw
Rung
(A)
(B)
Deck