Youngman boss solo 700, User Manual

Page: 5 / 24

\RXQJPDQJURXSFRP
029,1*7+(72:(5
Towers should be moved with caution.
Before moving, check the suitability of the intended route
to ensure there are no obstructions, both at ground level
and overhead. Wind conditions must also be considered.
People and materials must be removed and the height of
the tower reduced to 4.0m.
Finally, the stabalisers should be left in position and
raised no more than 25mm from the ground.
The tower must only be moved by applying manual effort
at, or near, the base of the tower and you should ensure
there are sufficient operatives on hand to control the
movement of the structure.
After moving and before use, check the tower is still
correct and complete. Use a spirit level to ensure that it
is vertical and level, then adjust the legs as required.
Do not move the tower in wind speeds over 7.7 metres
per second (17mph).
0$,17(1$1&(6725$*(75$163257
All components and their parts should be regularly
inspected to identify damage, particularly to joints. Lost
or broken parts should be replaced and any tubing with
indentation greater than 5mm should not be used and
put to one side for repair by the manufacturer.
Adjustable leg threads should be cleaned and lightly
lubricated to keep them free running.
Brace claws, frame interlock clips, trapdoor latches,
camlocks, claw mechanisms and platform windlocks
should be regularly checked to ensure they lock correctly.
Refer to the BoSS Inspection Manual and poster for
detailed inspection and maintenance advice:
youngmangroup.com/products/access-towers
Components should be stored in clean, dry conditions
with due care to prevent damage.
Ensure components are not damaged by excessive
strapping forces when transported.
6DIHW\)LUVW