6. Install (No. 6,7)
M5X10 BOLT
and
5MMFNUT,
bolt and nut onto the lower hole in muffler clamp.
7. Install (No. 5)
RACE-SPS-1,
medium exhaust
springs between muffler and tailpipe.
8. Torque tailpipe chassis mount bolt to factory
specification.
9. Torque the stock exhaust clamp on header to
factory specification.
10. Before starting vehicle, check for proper
clearance between new exhaust system and
rear suspension (i.e. tire, swingarm, brakes,
rear shock, and etc.) If any problem is found,
please carefully follow through the installation
steps again. If problem still persists, please call
Yoshimura Tech Department at (800) 634-9166 /
in CA (909) 628-4722.
11. It is recommended that the muffler and tailpipe
be wiped down with rubbing alcohol to remove
oil and fingerprints. This will help prevent
tarnishing of the finish after the exhaust is
heated up.
Note: After starting motorcycle, it is normal for
new exhaust system and muffler to emit
smoke until oil residue burns off.
4
