3
Removal
1. Remove the three exhaust heatshield bolts and
carefully remove the heatshield.
2. Using a short arm or modified allen wrench,
remove the exhaust valve cover on the stock
muffler to access exhaust valve cables.
3. Loosen exhaust valve cable nuts and remove
exhaust valve cables from the stock muffler
assembly.
4. Loosen the stock exhaust clamp between
header and muffler.
5. Remove the muffler chassis mount bolt.
6. While securely supporting the stock muffler,
remove the muffler mount bolt and carefully
remove the stock muffler assembly.
Note: The stock exhaust gasket will be re-used.
Inspect and replace if necessary.
7. Remove the passenger and rider seat.
8. Follow steps in Service/Owners Manual to
remove right side covers to access the servo
motor.
9. Remove the retaining clip securing exhaust
valve cables to the servo motor and carefully
remove the exhaust valve cables from pulley.
1
Note : Exhaust valve cables will not be used with
the Yoshimura Slip-On system.
2
Note : Do not disconnect servo motor connector
as it may potentially cause malfunction
indicators to appear on the display.
CAUTION: Exhaust system can be extremely hot.
Let motorcycle cool down before
beginning installation. Always wear
hand and eye protection and take
precautionary measures to avoid
injury.
WARNING: Always properly support vehicle with
a stand and/or lift when servicing or
performing any work. Unstable
vehicles may present dangerous
conditions and may cause property
damage and/or personal injury.
NOTE: Read through all instructions before
beginning installation.
10. Re-install the right side covers using the reverse
steps of removal.
11. Re-install rider and passenger seat.
Installation
1. Install (No. 4)
HT SHLDR77,
muffler clamp heat
insulator onto (No. 3)
MCYM5-DFCX(-X),
muffler
clamp.
2. Install (No. 1)
14800-435,
tailpipe inlet into the
stock header outlet.
3. Align chassis mount bracket to the front side of
chassis and secure using the stock chassis
mount bolt, washer, and supplied (No. 8)
10MMFNUT,
nut.
4. Install (No. 2)
muffler
onto (No. 1)
14800-435,
tailpipe.
5. Slide (No. 3)
MCYM5-DFCX(-X),
muffler clamp
over (No. 2)
muffler
and align to the stock muffler
mount. Secure using the stock muffler mount
bolt and nut. Torque to factory specification.
Note: Muffler clamp mounts to the frontside of
the muffler mount.
Stock
Nut
Stock Bolt
Muffler Clamp
Heat Insulator
Muffler
Clamp
1
2
