INTRODUCTION
The multi-purpose
Yorkville 100kw Power Wedge
mixer/amp has been designed to pro-
duce the most performance possible in a compact combo format. The
Yorkville 100kw
is
appropriate to use with just about anything that produces an audio signal. This includes
such items as professional or home keyboards, acoustic guitars (with pickups), microphones,
or other audio sources such as CD-players or even cassette decks. No matter what, the
Yorkville 100kw Power Wedge
will sound great and be dependable for years to come.
INPUTS
The
Yorkville 100kw
has two input channels, both input channels can be used simulta-
neously. As an example, you could use a microphone on
Channel 1
and a stereo key-
board on
Channel 2
. You can balance the loudness of the two sources by adjusting each
individual channel’s volume control.
C
Ch
ha
an
nn
ne
ell 1
1
Channel 1
is optimized for microphones, however the phone jack can also accept line
level inputs from an acoustic guitar (with pickup), electronic keyboard, CD-player or
other audio sources. This channel offers more gain than
Channel 2
, it’s advised that the
source with the lower level output be connected to
Channel 1
. Adjust the volume con-
trol for the level of sound desired.
This channel’s 1/4-inch input is balanced (T.R.S. or Tip/Ring/Sleeve, +/-/gnd). The
phone jack can also use regular, unbalanced, cables. For best results, and reduced noise,
it is advised that you use balanced (stereo) cables for interconnection wherever possible.
• Do Not use both the phone and XLR inputs on Channel 2 at the same time.•
The signals will be attenuated!
C
Ch
ha
an
nn
ne
ell 2
2
Channel 2
- This channel is optimized for line level signals such as an electronic key-
board, CD-players, cassette decks, or other audio sources. The channel also sums stereo
signals properly for use with this single amplifier system. You can utilize this feature
either by using the two phone jacks or the two RCA jacks (both sets of jacks can be used
at the same time). Adjust the
Channel 2
volume control for the level of sound desired.
TONE CONTROLS
The
LOW
and
HIGH
controls allow a wide range of tonal adjustment. The tone controls
affect the sound output from both channels. Increase or decrease the
LOW
control to
affect low frequency information and the
HIGH
control for high frequency information.
Please note: Due to the great variance between possible signal sources, it may be possible to dis-
tort the signal by adjusting the
LOW
or
HIGH
controls.
1
EFX SEND
EFX RTN
MIC
PHONES
POWER
15
15
12
12
9
9
6
6
3
3
HIGH
15
15
12
12
9
9
6
6
3
3
LOW
0
10
1
9
2
8
3
7
4
6
5
C
HANNEL
1
0
10
1
9
2
8
3
7
4
6
5
C
HANNEL
2
CD / LINE
LINE IN
LINE IN
KW
BAL
BAL
BAL
Yorkville
230V
50Hz
0.5A
120VAC
60Hz
1.0A
KW
