17
JOHNSON CONTROLS
FORM 150.68-ICOM1
ISSUE DATE: 10/15/2020
HANDLING AND STORAGE
DELIVERY AND STORAGE
To ensure consistent quality and maximum reliability,
all units are tested and inspected before leaving the
factory. Units are shipped completely assembled and
contain refrigerant under pressure. Units are shipped
without export crating unless crating has been specified
on the Sales Order.
If the unit is to be put into storage, prior to installation,
the following precautions should be observed:
• Ensure that all openings, such as water connec-
tions are securely capped.
• The unit should be stored in a location where there
is minimal activity in order to limit the risk of ac-
cidental physical damage.
• To prevent inadvertent operation of the pressure
relief devices, the unit must not be steam cleaned.
• It is recommended that the unit is periodically in-
spected during storage.
INSPECTION
Remove any transit packing and inspect the unit to
ensure that all components have been delivered and that
no damage has occurred during transit. If any damage
is evident, it should be noted on the carrier’s freight bill
and a claim entered in accordance with the instructions
given on the advice note.
Major damage must be reported immediately to your
local Johnson Controls representative.
MOVING THE UNIT
Prior to moving the unit, ensure that the installation site
is suitable for installing the unit and is easily capable
of supporting the weight of the unit and all associated
services.
The unit should be lifted using lifting lugs and a spreader
bar or frame of sufficient width to prevent damage to
the unit from the lifting chains.
The unit must only be lifted by the base
frame at the points provided. Never move
the unit on rollers, or lift the unit using a
fork-lift truck.
Care should be taken to avoid damaging
the ambient coil fins when moving the unit.
Units are provided with lifting holes in the base frame
which accept the accessory lifting lug set (part number
026L00261-000 - 4 lug set, 026-45594-000 - 6 lug set).
The lugs should be inserted into the respective holes in
the base frame and turned so that the spring loaded pin
engages into the hole and the flanges on the lug lock
behind the hole. The lugs should be attached to the
cables/chains using shackles or safety hooks.
Summary of Contents for YLPA 0115SE
