York YLCC-102, Technical Information

Page: 5 / 84

5
�����
�������� ����������
���
�
�
�
�
��� �
�����
���
���
���
���������������
Anti-vibratory supports (optional accessory)
Whenever a maximum reduction of vibration and noise gener-
ated by the unit is required, a set of steel spring anti-vibratory
supports can be used. These should be installed between
the supporting frame of the unit and the base or floor where
same is to be located. This base should be solid and sized
in accordance with the weight to be supported. 2MA bolts
are use to secure the supports to the base of the frame. This
anti-vibratory support accessory for YLCC-42/62 includes
4 springs, whereas for YLCC-82/02/22/52 it includes 6.
These spring supports should be distributed and secured by
means of the corresponding holes drilled in the chiller base,
the location of which is detailed in General Dimensions.
Flow switch (optional accessory)
Flow switch
Switch with a " MPT thread, adequate for a Design Operat-
ing Pressure of 0 bar hand so as to protect the equipment
against water flow drops. This switch, or an equivalent, should
be supplied for the site installation of each unit (obligatory).
Remote control unit with relays (optional accessory)
For system access and control by means of the correspond-
ing keys and LEDs. Allows selecting cool, heat or OFF func-
tions and indicates any failure by means of a red LED.
Can be installed at a maximum distance of 50 m. The remote
control module should be connected to the machine by means
of a 7 x 0.35 mm
2
cable.
Remote terminal (optional accessory)
For full system access and control by means of the display,
keys and LEDs. Allows selecting cool, heat and OFF func-
tions. Operating parameters can also be changed and the
system supervised. Can be installed at a maximum distance
of 040 m.