Indoor/Outdoor Unit Signal Wire
Connect the wire according to their numbers.
Panel Wiring
Connect the Swing Motor terminal block according to the Panel Installation Manual.
Wrong connection may cause malfunction .
Wiring Connection
Seal the wiring connection with the insulation material , or the condensing dew will be caused.
Terminal Board Diagram
Please refer to the indoor unit wiring diagram for the wiring.
Note: The air-conditioners can connect with Central Control Monitor (CCM). Before operation,
please wiring correctly and set system address and network address of indoor units.
Single phase indoor unit
CONTROL
Please number the indoor units during the installation . For example, for the first outdoor unit ,the number
of the first indoor unit is 1-1, the second indoor unit is 1-2, and the set address is 1 and 2
respectively , the others is analogical.
0 1
2
3
4
5
6
78
9
A
B
C
D
E F
ENC1
0 1
2
3
4
5
6
78
9
A
B
C
D
E F
ENC2
System address code
Hoursepower code
NUM_S
POWER_S
The reserved wire control function is indicated
in broken line table,users can purchase the
wire controller when necessary
To wire controller
P
Q
X
Y (E)
TO OUTDOOR
COMM. BUS
To Central Control
Monitor(CCM)COMM. BUS
TO INDOOR POWER
220V 50Hz/60Hz
Please adopt the shielded twisted-pair wire,
and connect the shielded layer to (E)
1
2
ON
SW1
13
(E)