Service manual
12
2.4.2 INSTALLATION OF THE UNIT INTO THE HOUSING
Slide the unit into the housing until it is firmly against the rear of the housing. Care is required to ensure the foam sealing strips on the housing remain in
position.
Connect the air conditioner to the power and position excess cord length
beneath the air conditioner base.
Engage the chassis fixing brackets into the bottom housing rail and
secure to the base with the screw provided.
Remove the front panel from it's carton and plastic bag and fit as per the
installation instruction.
Switch unit on. Check for operation of the unit and check for vibration in
the installation.
Fit the drain pan to the housing and run a drain line to a suitable location
if required.
2.4.3 INSTALLATION OF THE UNIT INTO THE WALL
2.4.4 INSTALLATION STEPS
Step 1. Remove the front panel and the air filter
Hold the slot under the front panel, then uplift it outwards, and remove the front panel (See Fig.1).
Pinch the handle under the air filter and make the air filter arched, remove it from the slot from
underside to upside (See Fig.2).
Step 2. Remove the frame.
Remove the two fixing screws from the frame (See Fig.3).
Grasp the left corner of the frame's underside, then loosen the frame (See Fig.4).
Step 3. Installation.
Remove the two fixing screws on the chassis fixing brackets, then remove the chassis fixing brackets
(See Fig.5).
Grasp the handle on the chassis and carefully slide the air conditioner out of the cabinet (See Fig.6).
Remove shipping pad from around compressor before operation and make sure the discharge points
to the drain pan are aligned before the chassis is pushed into the cabinet (See Fig.7).
Push the unit chassis into the cabinet (See Fig.8).
Install the two chassis fixing brackets using the two fixing screws (See Fig.5).
Step 4. Install the frame.
Install the frame making sure not to interfere with the temperature sensor cable (See Fig.9).
Fix the screws on the frame (See Fig.3).
Step 5. Install the air filter and front panel.
Install the air filter into the frame's slot from upside to underside (See Fig.2).
Hang the front panel on the frame's buckle, then press the front panel into the frame's slot until you hear a click (See Fig10).
