Automatic operation
When you set the air conditioner in AUTO mode,
it will automatically select cooling, heating
(cooling only type without), or fan only operation
depending on what temperature you have
selected and the room temperature.
Once you select the operating mode, the
operating conditions are saved in the unit’s
microcomputer memory.
Thereafter, the air conditioner will start operating
under the same conditions when you simply push
the ON/OFF button of the remote controller.
Start
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select AUTO.
2. Temperature button (TEMP)
Set the desired temperature. Normally, set it
between 21°C to 2 8°C
3. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
If the AUTO mode is uncomfortable, you can
select the desired conditions manually.
When you select the AUTO mode, you do not
have to set the fan speed. The fan speed will be
automatically controlled.
Handling the remote controller
Location of the remote controller
• Keep the remote controller where its signals
can reach the receiver of the indoor unit.
(A distance of 8m is allowed.)
•
When you select the timer operation, the
remote controller automatically transmits a
signal to the indoor unit at the specified time.
•
If you keep the remote controller in a position
that hinders proper signal transmission, a time
lag of up to 15 minutes may occur.
Replacing batteries
The remote controller uses two alkaline
dry batteries (R03/LR03X2).
(1) Slide the cover of the battery
compartment off according to the
arrow direction, then replace the old
batteries with new ones.
(2) Insert the new batteries making sure
that the (+) and (-) of battery are
installed correctly.
(3) Reattach the cover by sliding it back
into position.
5
4
CAUTIONS
•
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
•
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
•
If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
•
If other electrical appliances react to the remote controller, either move
these appliances or consult your local dealer.
J265_EN.indd 6
12/7/05 3:43:43 PM