10
CASSETTE
YORK CASSETTE (EN) 035T76015-000
8 - FRONT PANEL INSTALLATION
Unpack the front panel and disassemble the grille and filter. Fix the front panel with four screws to the hook plates
provided on the unit.
Make sure that there is no gap between the mounting surface on the unit and the front panel. Gaps may cause air
leakage and possible condensation.
Take care when installing the long screws in the front panel. Check the installation height of the unit again
(the front panel should be flush with the ceiling, otherwise air leakage will occur at the seal between the unit and the
front panel).
Once the long screws are inserted and tightened, plug the access holes with the rubber plugs provided. The outer
end of the rubber plugs is inclined and should be installed flush with the slope. Turn the plugs to suit their location
and press gently into place.
Panel Installation
•
The front panel can only be fitted in one direction, follow
the piping direction, (Follow piping arrow sticker on front
panel).
•
Be sure to remove the installation template before
installing the front panel.
•
Open the air intake grille by pull back the catchers and
remove it together with filter from panel.
•
Install the front frame panel onto the indoor unit by 4
screws and tighten it completely to prevent cool air
leakage,
•
Connect the LED wire with PCB board and air swing wire to the indoor unit.
AIR SWING
WIRE
LED WIRE
FROM
FRONT
PANEL
CONTROL BOX
OPEN
SCREWS
02_MKL-MKM.p65
13/6/02, 11:08 am
10