5-6 Operation Precaution
a.
MODE
button: when operating single unit with cooling only type, it can’t select Heating
mode. When controlling all, if only there is one heat-pump unit, then it can select Heating
mode. But if there are other units with cooling only type among the selected units, then
function confliction will be pointed out, but mode setting operation will not be limited.
b. If the set time is 0, then it means no TIMER operation. When first entering to TIMER
operation, the default time is 0, that is, no timer.
c. VENT. Auxiliary function is selected to start or close only by Auxiliary Function Button. If
there is only one unit that supports the selected auxiliary function, then this function can start.
Or, it can’t start. If there is only one unit that doesn’t support the selected started auxiliary
function, then function confliction will be pointed out, but mode setting operation will not be
limited.
d. When first entering into the setting page, it thinks single unit in default. If the
air-conditioners are in OFF state, then they will start according to COOLING mode, Set Temp.
24
, HIGH fan speed,
ºC
no TIMER and SWING function in default.
e. At any time, if pressing
ON/OFF
button, all present online air-conditioners will be carried
out ON/OFF operation. If only one online air-conditioner is in ON state, including ON/OFF
setting by delay, after pressing
ON/OFF
button, all online air-conditioners will be off. If all
present online air-conditioners are in OFF state, then it will send ON order as follows: if
pressing at Mode Setting Page, then it will carry out ON operation according to the present
selected Mode, Fan Speed, Set Temp., Timer and Auxiliary Function; if pressing at other time
and no selected Mode Setting data, then it will carry out ON operation according to COOLING
mode, Set Temp. 24
, HIGH fan speed,
ºC
no TIMER and SWING function in default.
5-7 Communicate with NIM
The CCM and NIM adopt main-auxiliary responsion communication. At any time,
continuously query the running state of one air-conditioner in network 10 times, if not
receiving the feedback data, then it thinks this air-conditioner is power off or doesn’t exist, and
no malfunction warning occurs. If receiving the feedback data, but the communication data is
wrong, then it thinks communication malfunction exists between CCM and NIM, and
malfunction code “
01#
” will be displayed. After normal communication, malfunction will relieve.
Or malfunction code will be eliminated after judging the air-conditioner is power off or doesn’t
exist.
5-8Communicate with Epigyny PC
If receiving data from Epigyny PC, then enter into network control state. If not receiving data
from Epigyny PC for 1 minute, then exit network control state. If data communication has
frame mistake or data check has mistake, CCM/PC communication malfunction will occur and
display malfunction code “
03#
”. Malfunction will relieve after communication restores to
normal state or exiting network control state.
