©York Survey Supply Centre 2018
Ref:.. \operat98\instructions 18\33405.qxp 05-01-18
Wireless Digital
Weather Station
Location of Controls
Main Unit Base
1. PRESSURE UNIT - Changes Barometric pressure
units: mb/inHg/mmHg/hPa
2. RAINFALL UNIT - mm/hr or in/hr
3. SNOOZE/LIGHT - Turns off the snooze alarm for
5 minutes until the alarm is switched off
4. HISTORY - Mean pressure / Daily rainfall total /
Weekly rainfall total / Monthly rainfall total / Season
rainfall total
5. MAX/MIN - Maximum/minimum indoor and outdoor
temperature and humidity
6. CLEAR - Clears barometric and rainfall history
display
7. ( + ) - Use to set the clock normally
8. SET - Use to set the clock normally
9. ( - ) - Use to set the clock normally
10. Clock with transmitter and rain gauge
11. °C/°F - Change display of indoor temperature
from celsius to fahrenheit and back
12. SNOOZE/ALARM ON/OFF - Turn off alarm or
alarm with snooze function
13. ADAPTOR JACK - Plug in 7.5V adaptor jack
14. DIMMER - Dims LCD backlight
15. RESET - Resets entire clock
Wireless Temperature/Humidity Sensor
(Transmitter)
1. SELECT
2. RESET
3. °C/°F
Wireless Rain Gauge
1. RESET
2. Re-sync
2
7
three seconds.
3. Dimmer switch on the base of the unit allows you
to adjust the brightness of the backlight to your
desired level.
°C/°F Button
Press the °C/°F button to select Celsius or
Fahrenheit display.
Reset Button
Press the RESET button when either the main unit or
remote transmitter unit is not operating properly.
Specifications
Temperature
Measure Range
Indoor/Outdoor (-19°C ~ 70°C) /
(-2.2°F ~ 158°F)
Resolution
Indoor 0.5°C/1°F
(MAIN UNIT)
Outdoor 0.1°C/0.2°F
(OUTDOOR TRANSMITTER) 0.1°C/0.2°F
Relative Humidity
Measuring Range Indoor 20% ~ 95%
Outdoor 10% ~ 90%
Resolution
Indoor/Outdoor 1%
Rain Gauge
Measuring Range 0.02 inch/hour ~ 10 inch/hour
(Rain rate less than 0.02
inch/hour shows 0.00 inch/hour)
Resolution
0.01 inch/hour
Barometric Pressure
Measuring Range 795mb ~ 1050mb
(23.48inHg ~ 31.01inHg)
Resolution
1mb (0.03inHg)
Warning:
Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Under the environment with radio frequency
interference, the sample may malfunction and
require user to reset the sample.
