background image

The EM / S motors type are motors with 2 way communication, 

a radio receiver and an emergency opening mechanism that 

allows opening or closing the gate or roller shutter in the event 

of a power failure. They have a mechanism for detection of 

obstacles, so that the motor stops if sensing resistance in its 

path. Detection of obstacles works in both directions, with the 

use of lock hangers.

Electronic limit position switches set by using the remote 

control provide ease of programming. Motors provide the 

ability to set the third position. 

EM/S series tubular motors are compatible with all

YOODA SMART HOME brand devices.

Radio receiver memory:

up to 10 transmitters

Max time of continous work:

4 min.

Power supply:

230 V / 50 Hz

Operating temperature:

from -5°C to 50°C

Protection degree:

IP 44

Tubular motor 45 EM/S with obstacle detection

Non-compliance with the specification might cause risk for life or health and can determine proper work of the blind.

We strongly recommend to comply with the specification.

Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence (SEP - Association of Polish

Electrical Engineers) or equal license.

Transmitters are compatible with all YOODA SMART HOME brand devices.

35EV/S and 45EV/S series tubular motors are compatible with all YOODA SMART HOME brand devices.

EM/S tubular motors are motors with two-way communication.

45 EM/S SERIES TUBULAR MOTORS

www.sukcesgroup.pl

1. General information

1

Maximal time of continuous work is 4 minutes. After that time thermal protection will be activated preventing motor form 

overheating. After that motor will be disabled for about 20 minutes until it cools down.

emergency opening socket

power supply cable

control system

emergency opening 

mechanism

motor

brake

gear

antenna

microswitch

capacitor

Summary of Contents for Smart Home 45 EM/S Series









Reviews: