3
6. Programming another transmitter
7. Deleting all transmitters
8. Activating impulse mode
9. Programming key-ring remotes
1. The receiver can be controlled by a maximum of 20 transmitters.
2. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
1. When impulse mode is activated, single push of UP or DOWN button forces motor to make single part of a full turn, and
when UP or DOWN button is being held for 2 seconds it will force motor to run constantly.
2. To reverse this procedure please repeat the instruction.
1. When programming key-ring remotes that do not have additional P2 programming button the same function is substituted
with simultaneous push of STOP and UP buttons.
2. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this method will result in deleting receiver memory.
Press
programming button P2
on the remote control.
Press
programming button P2
on the remote control.
Control unit
will make a sound.
Press
UP button.
Control unit
will make a sound.
Control unit will
make a few sounds.
When motor is in
impulse mode single push of
a button on the remote will
cause motor to make
short move.
Key-ring remote has
been programmed.
Turn on power supply
or press programming
button when
power is on.
Control unit
will make a sound.
Press simultaneously
STOP and UP
programming buttons.
Press simultaneously
STOP and UP
programming buttons.
Control unit
will make a sound.
Control unit
will make a sound.
Press
UP button.
Control unit
will make a few
sounds.
Control unit will
make a sound.
Press
programming button P2
on the A remote control.
Press
programming button P2
on the A remote control.
Press
programming button P2
on the B remote control.
Control unit
will make a sound.
Press
programming button P2.
All remotes
have been removed.
Control unit
will make a sound.
Press
programming
button P2.
Control unit
will make
a few sounds.
Press
STOP button.
Control unit will
make a sound.
Control unit
will make
a few sounds.
Remote control
has been programmed.
