2
3. Installation
4. Programming first transmitter
5. Changing work motor direction
Optimal mounting parameters:
1. Minimal length from the ground > 1,5 m,
2. Minimal length from the wall and ceiling > 0,3 m,
3. Minimal length between receivers > 0,2 m.
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence
(SEP - Association of Polish Electrical Engineers) or equal license. Device is designed to operate in places shielded from
unfavourable weather conditions. Motor should be installed in accordance with all provisions of regional law and profes-
sional standards. All cables connecting power receiver with electric source should be protected from overload and
short-circuits effects with devices automatically disconnecting power. Device should be powered with a separate source
and protected only with a fast-blow fuse (never slow-blow fuse). Creating electrical system using inadequate fuse may
result in loosing rights under the provisions of warranty. When connecting device to power source with cables with
adequate cross-section should be used. Long-lasting output load capacity table should be the ground for choosing
adequate cables.
1. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
2. Programming transmitter using this method will result in deleting receiver memory.
Turn on power supply
or press programming
button when
power is on.
Control unit
will make a sound.
Press programming
button P2 on the
remote control.
Press programming
button P2 on the
remote control.
Press UP button on
the remote control.
Control unit
will make a sound.
Control unit
will make a sound.
Control unit will make
a few sounds.
Transmmiter has
been programmed.
Turn on power supply
or press programming
button when
power is on.
Control unit
will make a sound.
Control unit
will make a sound.
Press programming
button P2 on the
remote control.
Press DOWN button
on the remote control.
Control unit
will make a sound.
Control unit
will make a sound.
Control unit will make
a few sounds.
Direction of the
motor work has
been changed.
power supply:
230 V / 50 Hz
motor:
230 V / 50 Hz
