Programming transmitters
1. Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
2. Procedure described below is to be used for programming first and all other transmitters. Receiver can hold in its
memory up to 20 different transmitters. Programming another transmitter will cause for the first transmitter on the list
of 20 already programmed to be deleted.
In order to fully explore available functions of MAGNETIC series please take a moment and read this manual before using the device. MAGNETIC transmitters
are compatible with all YOODA brand devices.
MAGNETIC_1CfT
www.sukcesgroup.pl
Changing automatic opening and closing time
Instructions described above, showing how to
set automatic opening and closing time, should
be repeated for every day of the week.
By pressing P1 CONFIGURATION CHANGE
button confirm new setting. Control unit
automaticaly switches to setting time of
automatic opening and closing for next
day of the week.
After setting automatic opening and closing time
for every day of the week press and hold P1
CONFIGURATION CHANGE button for about
3 seconds to confirm all changes
(current time starts to flash).
Switch power on.
Press and hold WORK MODE button
for about 6 seconds
('LEAr' sign start to flash).
Press STOP button
('LEAr' sing stops to flash).
Press STOP button on transmitter
that is beeing programmed.
'good' sign will flash three times
confirming, that new transmitter
was succesfully programmed.
Deleting transmitter
Deleting all transmitters
Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from
deleting mode without saving any changes.
Proceeding with this instruction will cause for all transmitters to be deleted form receivers memory.
Switch power on.
Press and hold STOP / DOWN
buttons at the same time
for about 6 seconds
('SET2' sign starts to flash).
'good' sign will flash three times
confirming, that all programmed
transmitter were successfully deleted.
Switch power on.
Press and hold WORK MODE button
for about 6 seconds
('LEAr' sign starts to flash).
Press STOP button
('LEAr' sing stops to flash).
Press DOWN button on transmitter
that is beeing deleted.
'good' sign will flash three times
confirming, that new transmitter
was successfully deleted.
