CAMELEO_1RwT | CAMELEO_5RwT
In order to fully explore available functions of CAMELEO series please take a moment and read this manual before using the device.
CAMELEO transmitters are compatible with all YOODA brand devices.
Activating channels in automatic mode
Setting current time
Changing automatic opening and closing time
www.sukcesgroup.pl
1. Each channel can be activated or deactivated in automatic mode.
2. If channel is deactivated transmitter will not control programmed radio receiver at preset time.
3. Channel is deactivated if its number is flashing.
4. In default mode all channels are active in automatic mode.
Time can be set only when device is in manual working mode.
Longer than 60 seconds pause between series of button clicks during programming will cause device to switch off from
time setting mode without saving any changes.
1. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear.
2. Changes to opening and closing time can be done only in automatic mode.
3. Longer than 60 seconds pause between series of button clicks during programming will cause device to switch off from
time setting mode without saving any changes.
4. Group channel needs to chosen for transmitter to control all devices at the same time. That applies to all working modes.
5. If while setting time of automatic opening or closing ‘--:--‘ symbol appears, it means that this time is not active in automatic
mode.
5. To leave time programming mode without saving any changes press STOP button.
By pressing
P2 programming button
for about 3 seconds
change work mode
to automatic or random.
By pressing ‘L1’ or ‘P1’
choose a channel.
By pressing
‘P1’ button for about 3 seconds
automatic mode is deactivated
on chosen channel.
Channel number is flashing.
Another pressing ‘P1’ button
for about 3 seconds
will activate automatic mode
on chosen channel.
Channel displays constantly.
By pressing ‘L1’ button
switch to day setting.
Using UP and DOWN buttons
set day of the week.
By pressing ‘P1’ button
for about 3 seconds
confirm new setting.
Pressing ‘L1’ button
will start the clock.
By pressing
P2 programming button
for about 3 seconds
change work mode to manual.
By pressing ‘L1’ button
for approximately 5 seconds
(hour starts to flash).
Using UP and DOWN
buttons set hour.
By pressing ‘L1’ button
switch to minute setting.
Using UP and DOWN buttons
set minute.
