2
BATTERY, ANTENNA & TIRE INSTALLATION
For glow plug igniter
Make a 1/2" diameter hole
For antenna pipe
Make a 1/4" diameter hole
For front body posts
Make two 1/4" diameter holes
For muffler pipe exhaust tip
Make a 1/2" diameter hole
Cut out windows to let cool air
inside the car. Nitro engines
require good air circulation for
proper cooling.
Cut along the cut-line when cutting
out the body.
Make sure to use
curved scissors for best results.
For rear body posts
Make two 1/4" diameter holes
For glow plug igniter
Make a 1/2" diameter hole
For antenna pipe
Make a 1/4" diameter hole
For front body posts
Make two 1/4" diameter holes
For muffler pipe exhaust tip
Make a 1/2" diameter hole
Cut out windows to let cool air
inside the car. Nitro engines
require good air circulation for
proper cooling.
Cut along the cut-line when cutting
out the body.
Make sure to use
curved scissors for best results.
For rear body posts
Make two 1/4" diameter holes
BATTERY INSTALLATION
Before your car can be run, you will need to install the batteries into your car and radio
transmitter. A total of twelve AA batteries are required: four batteries are required for
the battery box, and eight are required for the radio transmitter. The instructions for the
installation of the radio transmitter batteries is included in the radio transmitter manual.
3x10mm Screw
Upper Battery Support
AA Battery
Battery Box
Install four AA batteries
into the battery box.
To access the battery box remove
the two 3x10mm screws and the
upper battery support.
Once the batteries have been
installed, insert the battery box into
the radio plate and place the upper
battery support
ANTENNA INSTALLATION
Slide the antenna wire through the antenna pipe and insert the
antenna firmly into the radio plate.
STEPS FOR PAINTING AND MOUNTING THE BODY
1. Wash the inside of the body with warm soapy water and dry off with a towel.
2. Apply the window masking to the inside of the body.
3. Spray the inside of the body with paint for Lexan. Only use paint for Lexan!
4. Spray the inside of the wing with paint for Lexan also.
5. Allow the paint to dry in a well ventilated area.
6. Remove the clear protective film and window masking.
7. Cut out the body and wing by cutting along the cut line around the body.
8. Attach the wing to the body with the screws and nuts included with the body.
9. Drill the all of the holes indicated below. Hole locations are marked on body.
10. Apply decals to the outside of the body.
11. Adjust body clips on body posts for proper body fitment and secure with body clips.