YPP6870 Loop-Powered Process Meter
Instruction Manual
8
Electromagnetic Compatibility
EMISSIONS
EN 61326:2006
Safety requirements for measurement, control, and
laboratory use – Industrial
Group 1 Class A ISM emissions requirements
Radiated
Emissions
Class A
IMMUNITY
EN 61326:2006
Safety requirements for measurement, control, and
laboratory use
ESD
±4 kV contact,
±8 kV air
RFI – Amplitude
Modulated
80-1000 MHz @ 10 V/m,
1.4-2.0 GHz @ 3 V/m,
2.0-2.7 GHz @ 1 V/m,
80% AM (1 kHz)
EFT
±2 kV DC mains, ±1 kV other
Telco Surge
±1 kV
CRFI
3 V, 0.15-80 MHz, 1 kHz 80% AM
SAFETY INFORMATION
WARNINGS
•
Read complete instructions prior to installation and operation of the meter.
•
Installation and service should be performed only by trained service
personnel. Service requiring replacement of internal components must be
performed at the factory.
•
Disconnect from supply before opening enclosure. Keep cover tight while
circuits are alive. Conduit seals must be installed within 18" (450mm) of
the enclosure.
•
Verify that the operating atmosphere of the meter is consistent with the
appropriate hazardous locations certifications.
•
If the meter is installed in a high voltage environment and a fault or
installation error occurs, high voltage may be present on any lead.
